The platform was the original verification target of seL4 over 10 years
ago and by now there doesn't appear to be any ways to obtain new
hardware.
Currently, the KZM platform is the only ARMv6 platform and supporting it
requires a few work-arounds for emulating mechanisms that newer hardware
supports. Removing this platform also implies removing armv6 support
soon.
Signed-off-by: Kent McLeod <kent@kry10.com>
All the kernel header files now use pargma once rather than the ifndef,
as the pre-processed C files do not change while header files
are protected with pargma once. This will also solve any naming issues
caused by ifndef.
This commit also converts our own copyright headers to directly use
SPDX, but leaves all other copyright header intact, only adding the
SPDX ident. As far as possible this commit also merges multiple
Data61 copyright statements/headers into one for consistency.
Added support for reading and writing additional virtual timer
registers for vcpu hw read and write accesses. These include the
compare value register (CNTV_CVAL) and offset register (CNTV_OFF),
each represented as two 32 bit (high and low) registers on aarch32 and
as single 64 bit registers on aarch64.
Added support for explicitly saving and restoring the virtual
timer registers when the vcpu is enabled and disabled. This
ensures when the vcpu is switched in and out, the virtual timer
registers are restored to a state that is consistent to when
it was last run.
By default the CNTVOFF register will be updated by the kernel to
accumulate the time the VCPU is not running. From the guest this will
result in the VCNT register not increasing when the VCPU is suspended.
This behavior can be turned off by disabling the
KernelArmVtimerUpdateVOffset config option.
On exynos5 platforms the Arm Generic timer is available and is used for
MCS, but the mct.h is still used as the mct device needs to be
configured to implement the Arm Generic timer. mct.h is a common header
for register definitions while exynos4412-mct.h is used for implementing
timer functions on the exynos4 where the mct doesn't support being the
Arm generic timer.
Also remove misplaced initGenericTimer() declaration.
- use gpt, so we can have overflow and compare interrupts at the same
time (epit only allows compare)
- set the gpt to use the ipg_highfreq timer, as the standard ipg is too
low and breaks the timer calculations
Update the generic timer to implement the MCS kernels tickless timer
driver API and update all platforms that use the arm generic timers:
- bcm2837
- exynos5
- hikey
- imx7
- odroidc2
- tk1
- tx1
- tx2
- zynq7000
Also move the generic timer constants to machine.h to avoid a circular
dependency.
